Axor Microspeed Plus Series - Detailed Configuration and Tuning; 5.0 Personalization and Settings

45
Service Manual
Plus
MICROSPEED
Adjustments
5.0 Personalizazion and Settings
Soldering points
Personalization base
adjustments
If the drive isnt adjusted with the proper servomotor, follow these
procedures. If changes need to made to the internal drive setting
powering, please wait at least 10 seconds after the power has
been removed and the OK LED is off.
All of the personalizations are located inside of the MICROSPEED
PLUS. To gain access to the adjustment pads and the solder
bridges, unscrew (A) , and remove the cover (B). (See figure
above).
A
A
B