Axor Microspeed Plus Series - 5.6 Nominal and Peak Current Adjustment

53
Service Manual
Plus
MICROSPEED
Adjustments
5.6 Nominal and Peak Current Adjustment
Peak Current
Note * = No resistor mounted.
Nominal Current
Note * = No resistor mounted.
The Microspeed Plus is pre-set to the nominal current rating
of the drive, if a lower current is needed to match the motor
used, refer to the chart below and select the correct resistor
value to be fitted as RIN. Use the table below to select the
correct value.
To reduce the value of the peak motor current , its necessary
to mount RIP on the header located inside of the drive.Use
the table below to select the correct value.
eulaVNIR
mhoKni
* 33 22 51 01 8,6 7,4 3,3 2,2 5,1 1
2/1SCM
1 69,0 29,0 68,0 87,0 17,0 36,0 55,0 64,0 93,0 23,0
5/5,2SCM
5,1 4,2 3,2 1,2 9,1 7,1 5,1 3,1 2,1 1 8,0
21/6SCM
6 8,5 5,5 2,5 7,4 3,4 8,3 3,3 7,2 3,2 2
02/01SCM
01 6,9 2,9 6,8 8,7 1,7 3,6 5,5 6,4 9,3 2,3
82/41SCM
41 7,31 31 2,21 2,11 01 9,8 7,7 5,6 4,5 5,4
04/02SCM
02 2,91 4,81 2,71 6,51 2,41 6,21 11 2,9 8,7 4,6
eulaVPIR
mhoKni
* 86 74 33 22 51 21 01 2,8 8,6 6,5
2/1SCM
2 9,1 8,1 7,1 6,1 5,1 4,1 3,1 2,1 1,1 1
5/5,2SCM
5 8,4 6,4 4,4 4 7,3 4,3 2,3 3 7,2 5,2
21/6SCM
21 5,11 1,11 6,01 8,9 9,8 3,8 7,7 2,7 6,6 6
02/01SCM
02 3,91 6,81 7,71 3,61 8,41 8,31 9,21 21 11 01
82/41SCM
82 72 62 52 32 7,02 3,91 81 7,61 4,51 41
04/02SCM
04 6,83 2,73 4,53 6,23 6,92 6,72 8,52 3,42 22 02