Azbil SDC15 User Manual

5-14
Chapter 5. SETTINGS BEFORE STARTING OPERATION
Operation type Set value Direct action Reverse action
of operation
type
SP low limit 11
SP high/low limit 12
MV high limit 13
MV low limit 14
MV high/low limit 15
Heater 1 burnout/ 16
Over-current
Heater 1 17
short-circuit
Heater 2 burnout/ 18
Over-current
Heater 2 19
short-circuit
Main setting
SP
Main setting
SP
ONHYS
ON
HYS
Main setting Sub-setting Main setting Sub-setting
SP
SP
ON
HYS
ONHYS
ONHYS
HYS
ONHYS
ON
HYS
Main setting
Main setting
MV
MV
Main setting
MV
Main setting
MV
ONHYS
ON
HYS
Main setting
Sub-setting
MV
ON
HYS
ONHYS
ONHYS
HYS
Main setting
Sub-setting
MV
Main setting
Sub-setting
CT1 at output ON. CT1 at output ON.
ON
HYS
ONHYS
ONHYS
HYS
Main setting Sub-setting
OFF before measuring the CT1 current value OFF before measuring the CT1 current value
ONHYS
ON
HYS
Main setting
Main setting
CT1 at output OFF. CT1 at output OFF.
OFF before measuring the CT1 current value OFF before measuring the CT1 current value
Main setting
Sub-setting
CT2 at output ON. CT2 at output ON.
ON
HYS
ONHYS
ONHYS
HYS
Main setting
Sub-setting
OFF before measuring the CT2 current value OFF before measuring the CT2 current value
ONHYS
ON
HYS
Main setting
Main setting
CT2 at output OFF. CT2 at output OFF.
OFF before measuring the CT2 current value OFF before measuring the CT2 current value
● shows that the ON/OFF is changed at this value.
❍ shows that the ON/OFF is changed at a point that
"1U" is added to this value.
● shows that the ON/OFF is changed at this value.
❍ shows that the ON/OFF is changed at a point that
"1U" is added to this value.

Azbil SDC15 Specifications

General

Brand	Azbil
Model	SDC15
Category	Controller
Language	English