53
10.6 microspeed® uni mini pistol handpiece GD684
Motor speeds/setting
Step width/setting for tapping
Note
The step width set for “to the right” (forward) must always be larger than
the step width set “to the left” (backward).
Step width/Settings oscillating operation
Note
The step width settings for rotation “to the right” (forward) and “to the left”
(backward) are always identical.
11. Disposal
Note
The user institution is obliged to process the product before its disposal, see
chapter Processing.
Always adhere to national regulations when disposing of or recycling the
product or its components!
If you have any questions concerning the disposal of the product, please
contact your national B. Braun/Aesculap agency, see chapter Technical
Service.
12. Distributor in the US/Contact in Canada
for product information and complaints
Aesculap Inc.
3773 Corporate Parkway
Center Valley, PA 18034
USA
Parameter Speed/Setting
Step width for speed range upper limit setting 1,000 1/min
(for speed range
upper limits below
1,000 1/min in steps
of 250 1/min)
Motor direction settings
(optical and acoustic notification for left
rotation)
- right rotation
- left rotation
Maximum speed range upper limit 16,000 1/min
Minimum speed range upper limit 500 1/min
Minimum speed setting 300 1/min
Factory setting 16,000 1/min
Parameter Setting
Step width settings 15°-angle at the tip
(16:1 gear)
Setting range for right rotation 105–405°
Setting range for left rotation 45–345°
Factory setting 270° to the right
90° to the left
Parameter Setting
Step width settings 15°-angle at the tip
(16:1 gear)
Setting range 45–405°
Factory setting 210° (right and left)
Products carrying this symbol are subject to separate
collection of electric and electronic devices. Within the
European Union, disposal is carried out without fees by
the manufacturer.
To Next Page
Loading...
