49
DEALER MANUAL MAX DRIVE SYSTEM
6.5.2 Setting Preparation
When the display is active, press twice (interval
< 0.3 seconds). The system will enter the MENU pa-
rameter setting state, in which the display parameters
can be set. Press twice again (interval < 0.3
seconds) to return to the main menu.
Menu for entering the parameter settings
In the parameter setting state, when the parameter you
want to set begins to flash, press / to adjust the
parameter value. Briefly press to switch between
the parameters to be set. Press twice (interval
< 0.3 seconds) to exit the submenu.
If no operation is performed for 10 seconds, the display
will return to the normal riding display.
6.5.3 Data Reset
Press
twice (interval < 0.3 seconds) – the display
enters the MENU state. In the speed field tC is dis-
played. If you press , a y is also displayed. Now all
temporary data, e.g. maximum speed (MAXS), average
speed (AVG) and single-trip distance (TRIP) can be
cleared. Briefly press (< 0.3 seconds) to enter the
km/mile setting interface.
If the user does not reset the data, the single trip
distance and the accumulated total riding time will
be automatically cleared when the accumulated total
riding time exceeds 99 hours and 59 minutes.
The data will not be cleared when the display’s light-
sensing function is set to 0 or when it is switched off.
6.5.4 km/mile
When the speed field displays S7, press / to
switch between km/h and mph, or to set km or mile.
After this setting, briefly press
(< 0.3 seconds) to
enter the setting interface of light sensitivity.
To Next Page
Loading...
Need help?
General
