vi I-E96-409A
Safety Summary
®
GENERAL
WARNINGS
Equipment Environment
All components, whether in transportation, operation or storage
must be in a noncorrosive environment.
Electrical Shock Hazard During Maintenance
Disconnect power or take precautions to insure that contact with
energized parts is avoided when servicing.
SPECIFIC
WARNINGS
If input or output circuits are a shock hazard after disconnecting sys-
tem power at the power entry panel, then the door of the cabinet
containing these externally powered circuits must be marked with a
warning stating that multiple power sources exist. (p. 2-8)
SPECIFIC
CAUTIONS
Remove modules (slave, master or termination) from their assigned
slots before installing a cable to that slot. Also, remove stations from
their housing before installing a cable to that housing. Failure to do
so could result in damage to the module or station. (p. 2-5)
It is strongly recommended that
all
power (cabinet, I/O, etc.) be
turned off before doing any termination module wiring. Failure to do
so could result in equipment damage. Do not apply power until all
wire connections are verified. (p. 2-8, 4-1, 4-2)
To Next Page
Loading...
