108
H Terminators must only be fitted at both ends of the network, not at intermediate nodes.
H The 0V rails of all of the nodes on the network must be tied together through the CAN cabling.
This ensures that the CAN signal levels transmitted by MintDrive or CAN peripheral devices are
within the common mode range of the receiver circuitry of other nodes on the network.
MintDrive supports the full range of Baldor CAN peripherals - InputNode 8, OutputNode 8, RelayNode
8, ioNode 24/24 and KeypadNode.
To Next Page
Loading...
Need help?
General
