104 P/N 133487
Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SC22-3 Safety Controller
Instruction Manual
Appendix B
Manual Reset
The RS01 Properties menu appears.
• Change the Circuit type to Single-channel, 2-terminal.
• Click OK.
This single “common” manual reset signal will reset all of the
safety outputs. (For the purposes of this tutorial, one common
manual reset signal is used to reset all of the safety outputs. In
a real application, it is possible to assign a separate reset for
each safety output, if needed. To do this, choose the Circuit
Type from the Reset Properties menu, and then select the
safety output that the reset device should reset. Individual Reset
Properties menus will appear until all safety outputs that are
controlled by an input device with manual reset have a reset
assigned.)
Your Wiring Diagram should look like this:
Your Ladder Logic Diagram should look like this:
To Next Page
Loading...
