P/N 133487 103
Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SC22-3 Safety Controller
Instruction Manual
Appendix B
B.5 Create a Configuration
• Click on the System Settings icon on the right-hand
side of the tool bar.
The pop-up System Settings menu will appear.
• Name the configuration file CFG1. (Up to 16 alphanumeric
characters may be used.)
• Add your name in the Author’s name box. (Up to 10
alphanumeric characters may be used; abbreviate as needed.)
• Keep the default settings listed below.
Power up mode: Normal
Mute on power up: No check mark
Monitored system reset: Check mark (click on the checkbox
to select or deselect it.)
Your System Settings menu should look like this:
• Click OK.
Add an E-Stop Button Input
• Click on the Wiring Diagram tab, if the wiring diagram is not
already displayed on the screen.
• Click on the Add Safety Input button in the center of the tool
bar. The Add Safety Input Device pop-up menu will appear.
Select Emergency Stop Button Properties
• Double-click on the Emergency Stop icon in the Add
Safety Input device menu. The ES01 Properties menu will
appear. (Abbreviated, sequentially numbered device names are
automatically assigned but can be changed.)
• Name: Keep ES01.
• Circuit type: Keep the Dual-channel, 4-terminal. (Use the
drop-down Circuit Type field to see other circuit
options.)
• Reset logic: Keep the default Manual.
• Map to: Keep the ES01 mapped to all three safety outputs
(SO1, SO2, SO3).
• Click OK.
Because a manual reset signal was chosen for the E-stop button,
when OK is selected and the ES01 Properties menu closes, the
RS01 Properties Manual Reset screen will appear automatically.
Helpful Hint: If you want to
access more information about
a device and which circuit types
provide what level of safety,
click on the Info button. It will
immediately bring up the section
from Appendix A of this manual
that provides that information for
the displayed input device.
To Next Page
Loading...
