Banner SC22-3 - Configure Status Output 02

118 P/N 133487
Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SC22-3 Safety Controller
Instruction Manual
Appendix C
Edit Inputs menu
ESC→
Edit Configuration menu
Configure the Status Outputs
To configure the status outputs, select Outputs/System
Settings and press OK.
Select Status Outputs and press OK.
Use the left/right arrow keys to select the status output to
configure. In this case, select Status Output 01 and press OK.
The next menu displayed is the Status Output Properties
menu. From this menu you can configure the status output(s).
Configure:
• Status output 01 to track the state of ES01
• Status output 02 to signal when a reset operation is needed
for Safety Output SO1
Configure Status Output 01
Change the name of 01 by selecting Change Name and
pressing OK.
Use the left/right arrow keys to select the character to be
changed (up to 10 characters).
Use the up/down arrow keys to change the character (choices
A-Z, 0-9, -, +, or space).
Set the name to ES01 and press OK.
The display returns to the Status Output Properties menu. The
top line of the display now displays the name assigned to the
status output.
Configure the status output to track an input. Select Select
Function and press OK.
Using the left/right arrow keys, select Track Input and press OK.
The display returns to the Status Output Properties menu.
Configure the status output to track the E-stop input, ES01.
Select Select Source and press OK.
Using the left/right arrow keys, select ES01 and press OK.
The display returns to the Status Output Properties menu.
Status output 01 is now configured. To save the settings, select
<Done> and press OK.
The display returns to Outputs/System Settings menu.
To configure additional Status Outputs, select Status Outputs,
select the status output to configure and repeat the steps that
were performed for status output 01.