To Next PageTo Next Page
Need help?Do you have a question about the Banshee 700 and is the answer not in the manual?
General| Power Source | Electric |
|---|---|
| Motor Type | Brushed |
| Chassis Material | Plastic |
| Drive Type | 4WD |
| Terrain | Off-Road |
Details the key design and mechanical characteristics of the helicopter.
Lists performance metrics, weight, and motor/rotor speed ratios for the model.
Lists compatible motors and electronic speed controllers for the helicopter.
Provides guidance on suitable battery types and servo models for optimal performance.
Suggests flybarless systems and main/tail rotor blade specifications.
Outlines essential preparation steps, screw security, and tool recommendations before assembly.
Details connecting the main rotor shaft to the main pulley and intermediate shaft.
Covers mounting the main belt and installing the belt tensioner mechanism.
Describes the attachment of the freewheel pulley and dome brace components.
Instructions for installing rotor head damping into the main rotor housing.
Guides on securing SP-towing arms and attaching carrier ball joint heads.
Details the process of inserting feathering shafts and sliding on blade holders.
Explains how to secure blade holders and position thrust bearings correctly.
Covers the initial assembly of tail rotor parts, including bearings and thrust washers.
Details attaching the tail rotor hub, blade holders, and feedback levers.
Instructions for mounting the tail rotor housing onto the tail boom and securing components.
Describes installing the tail pulley, push rod, and aligning the bellcrank.
Steps for preparing chassis plates and mounting initial components like the belt tensioner.
Details attaching the gear unit, securing dome braces, and fitting silicone tubing.
Covers the installation of the landing gear, chassis connectors, and tail boom clamp bracing.
Instructions for inserting tail boom clamps and assembling the RC unit mounting platform.
Guides on fitting the RC unit and swashplate into the main chassis structure.
Instructions for sliding the pre-assembled rotor head onto the main rotor shaft.
Details connecting ball sockets to swashplate and adjusting connecting rod lengths.
Covers positioning the tail boom, tail belt, and securing them in the clamps.
Explains how to increase tail belt tension and align the tail rotor.
Guides on screwing the motor carrier and canopy bracket to the chassis.
Recommends wiring all R/C components and setting servos to their neutral positions.
Details screwing balls to servo horns and mounting the tail servo to the RC unit.
Guides on installing the elevator servo, using shims for alignment.
Instructions for positioning the receiver and routing its antennae through the chassis.
Covers preparing servo push rods and connecting them to the swashplate and servos.
