5. Preparing the buttons
5. PREPARING THE BUTTONS
Overview
• Pairing
• Pre-install of the Launcher service
5.1 Pairing
Pairing of the Buttons with the Ba se Unit
To be able to use a B utton it should be assigned to the Base U nit yo u are using. Th is proc ess is called pairing. B y default, the two
Buttons delivered with the ClickS hare set are already paired to the specific Base Unit.
In case you buy a dditional B uttons or when a Button should be assigned to another Base Unit, the But
ton needs to be paired (again).
When updating the Base Unit software, it is advised to also pair your Buttons w ith the Base Unit to update their software.
A Button can only be paired to one Base Unit at a time.
The Bu tton will always make connection to the Base Un it it was last paired to.
To pair a Button to the Ba se unit
1. Insert the Button in the US B port at the front of t he Base Unit you are us ing.
Image 5-1
Pair button
R5900014 CLICKSHARE 16/09/2013 21
To Next Page
Loading...
