On-screen display (OSD)
57
Reading room selection
This function is available only when the DICOM display function is
selected and Continuous DICOM ALC is off.
To select a reading room setting:
1. Select the DICOM display function. See To select a display
function (DF):, on page 53.
2. Switch Continuous DICOM ALC off. See To switch continuous
DICOM ALC on/off:, on page 55.
3. In the ALC & DICOM Options menu, use Up
or Down to select
Reading Room. Use Enter
to go into edit mode.
4. Use Up
or Down to select the reading room that corresponds
to the room type the display is installed in.
Measured ALC The DICOM DF will be recalculated
taking the averaged measured
ambient light value into account
that is determined by the selected
Reading Room. This value can be
changed by executing the “Measure
ALC Value” function in the Reading
Room Definition submenu.
Value Description
To Next Page
Loading...
Need help?
General