Barco FLM HD20 - Common Address; Serial Communication; Baud Rate Setup

13. Projector control
13.2.2 Common address
About common address
A common address can be ’0’ or ’1’.
Any command coming from a remote control programmed with that common address will be executed.
How to change the common address?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER.
3. Use the ▲ or ▼ key to select Projector address and press ENTER.
4. Use the ▲ or ▼ key to select Common address and press ENTER.
The edit common address window opens.
5. Use the ▲ or ▼ key to select ’0’ or ’1’
Or,
enter ’0’ or ’1’ with the digit keys on the remote control or local keypad.
6. When the desired address is entered, press ENTER to store that address.
Image 13-5
Image 13-6
Image 13-7
Image 13-8
13.3 Serial communication
Overview
• Baud rate setup
• Interface standard
• RS422 termination
13.3.1 Baud rate setup
What can be done?
The baudrate for a serial connection with a computer can be set up.
How to set up?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER.
3. Use the ▲ or ▼ key to select Serial communication and press ENTER.
The serial communication menu opens.
R59770180 FLM HD20 11/07/2008
141