17. Removal of the projector covers
Image 17-12
4. Secure the side cover by locking the captive screw in the middle at the bottom of the side cover.
Image 17-13
17.7 Installation of the lamp cover
Necessary tools
7mmflat screw driver.
How to install the lamp cover of the projector ?
1. Install the lamp cover of the projector doing the following:
a) Bring the lamp cover towards its final position (A),
b) then gently push the locking stud at the left top corner (B) into its receiver,
c) then gently push the locking stud at the left bottom corner (C) into its receiver.
Image 17-14
2. Secure the lamp cover by locking the two captiv
e screws at the right side of the lamp cover.
Image 17-15
184 R59770180 FLM HD20 11/07/2008
To Next Page
Loading...
