6. Getting started
Ind. Key name Description
15 FREEZ
To freeze the actual projected image. Freeze sign is displayed in the upper left corner.
16 TEXT Toggle key to activate or deactivate on screen text boxes while adjusting a setting.
When adjusting one of the image controls, e.g.during a meeting, the normally displayed
bar scale can be deactivated by pressing ’TEXT’ key first. To re-display the bar scale
on the screen, press ’TEXT’ key again. When TEXT is ’off’, no adjustment menu’s
will be displayed on the screen when entering the adjustment mode. All menus and
adjustments remain active on the local LCD panel.
17 ENTER
Key to confirm an adjustment or selection in the adjustment mode.
18
Cursor keys
To make menu selections when in the adjustment mode
19 EXIT Key to go one menu stage higher than the actual position when in the adjustment mode.
20
WINDOW Selection of the active window, also in PIP mode.
21 PIP
Direct access key for picture in picture selection.
22
RC Operating indication Lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
Tabl e 6 -1
6.3 Operating the projector
Overview
• Switching on
• Errors, warnings and messages during start up
• Switching to standby
• Switching off
6.3.1 Switching on
Howtoswitchon.
1. Press the power switch to switch on the projector.
Image 6-2
Switching on
- When ’0’ is visible, the projector is s
witched off.
- When ’1’ is visible, the projector is switched on.
The projector starts up in standby. The menus are accessible via the local LCD panel.
To display an image, the standby key must be pressed once.
The actual input voltage is indicated on the voltmeter just above the power switch.
Starting image projection via the standby key.
1. Press Stand by key once on the local keypad or on the remote control.
R59770180 FLM HD20 11/07/2008 45
To Next Page
Loading...
