Barco FLM HD20 - FLM Flight Case; Projector Configurations

2. General
2.4 FLM flight case
Introduction of the FLM flight case
The FLM flight case is designed to transport the FLM HD20 in a safe and secure manner. The four caster wheels, provided with
breaks, and the eight handles make the FLM flight case easy to handle. The floor of the flight case wagon is equipped with two
small covered compartments to store the remote control and the rigging clamps. Furthermore, three Velcro strips are attached to
the bottom for fastening the power cord of the projector.
Image 2-4
FLM flight case (R9854510).
The dimensions of the FLM flight case are optimal for maximum utilization of the floor area of a truck. The cover of the FLM flight
case has four stacking dishes, which allows to stack the flight cases.
2400 mm
1
6
0
0
m
m
Image 2-5
WARNING: Maximum stack two (2) FLM flight cases high. Never higher.
CAUTION: Prior to inserting project
or in flight case turn in the adjustable feet and interlocking adapters fully.
2.5 Projector configurations
The different configurations
Depending on the installation the projector can be mounted in different ways, the 4 different configurations are:
1. Front / Table (F/T)
2. Front / Ceiling (F/C)
3. Rear / Table (R/T)
4. Rear / Ceiling (R/C)
Front projection
The projector is installed, either in a table mount or ceiling mount configuration, at the same side of the screen as the audience.
14
R59770180 FLM HD20 11/07/2008