Barco LED-PRO - Page 157

LED-PRO • User’s Guide 143
_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä
LED-PRO Remote Commands
• Query:
ISMP? in
Returns the Input Sample Mode in the format
= n
S ISMP 1 0 (Adjusts Input Sample mode of channel 1 to OverSample)
S ISMP? 1 (Queries Input Sample Mode of channel 1)
fpvk`=áå=ãçÇÉ
• Description: Adjusts the Input Sync selection.
• Parameters:
in - Input chnl [1-3]
mode - Mode [0|1|2|3], Auto|H/V|CSync|SOG
• Query:
ISYNC? in
Returns the Input Sync selected for the specified input channel in the format
= mode
S ISYNC 1 1 (Sets Scaler to expect H/V sync on input channel 1.)
S ISYNC? 1 (Queries Input Sync selected for channel 1)
fpvk`pif`b=áå=ååå
• Description: Adjusts the Input Sync Slice Threshold selection.
• Parameters:
in - Input chnl [1-3]
nnn - Sync Slice Threshold [20 - 280mV (in steps of 10)]
• Query:
ISYNCSLICE? in
Returns the Input Sync Slice Threshold selected for the specified input channel in
the format
= nnn
S ISYNCSLICE 1 60 (Sets Sync Slicer threshold to 60mV for channel 1.)
S ISYNCSLICE? 1 (Queries Input Sync Slicer threshold for channel 1)
fqvmb=áå=ãçÇÉ
• Description: Sets the Input Type. Note: If Auto Acquire is On, setting Input type
with this command may be overridden. Input Type DVI is only available on input
channel 1.
• Parameters:
in - Input chnl [1-3]
mode - Mode [0|1|2|3], RGB | YPbPr | NTSC/PAL/SECAM | DVI (DVI
available only on chnl 1)