Barco RLM-W14 - Page 31

31 of 149
Barco RLM W14 Operation Commands
Command
Item
Operation
Commands
Values
Notes
0.7
f.search
= ?
0 = F1 Search
1 = F2 Search (default)
0.8
sdi.3gccir
= ?
0 = TRS
1 = CCIR
0.9
DarkTm.sel
= ?
0 = 650 us
1 = 1300 us
2 = 1950 us
Note 19
0.10
3dsync.inv
= ?
0 = Off
1 = On
Note 19
0.11
3dsync.dly
= ? + -
-32000~32000
Note 19
In microseconds
0.12
3dsync.ref
= ?
0 = Internal
1 = External
Note 19
0.13
(Reserve)
(Reserve)
(Reserve)
(Reserve)
0.14
(Reserve)
(Reserve)
(Reserve)
(Reserve)
0.15
(Reserve)
(Reserve)
(Reserve)
(Reserve)
0.16
(Reserve)
(Reserve)
(Reserve)
(Reserve)
REMARK: An input command will get back with “NA” when the input command is “Not Applicable” in
some specific conditions.
Note1: Not applicable in standby mode.
Note2: Not applicable in standby mode or without signal locked.
Note3: Not applicable when picture mute is on.
Note4: Only valid when source is one of Composite, S-Video and RGB-S.
Note5: Native aspect ratio is not applicable when zoom is set to “Zoom”, Letterbox aspect ratio is not applicable
when the input format is one of formats as listed in appendix 2.
Note6: Selection “Zoom” is not applicable when aspect ratio is set to Native.
Note7: Only applicable when source is one of RGB D-15, YUV1 and RGBHV/YUV2.
Note8: Not applicable when color space is set to custom.
Note9: pip.sel can NOT be set to 0.
Note10: Not applicable when pip is off.
Note11: Not applicable when lamp is cooling.
Note12: Not applicable when eco.net.pow is on.