R5911443 /02 UDM88
Image 8-33
There are now two vectors on each side of the picture that can be adjusted individually.
2. Select the desired slider and confirm.
Image 8-34: Right vector of the upper side of the picture.
3. Adjust angle and linearity (length) individually to obtain the correct correction and confirm.
Tip: Adjust the angle by using the up and down arrow keys. Adjust the linearity by using the left and
right arrow keys.
Image 8-35
4. Repeat the step for each side of the picture that must be corrected.
GUI – Installation
To Next Page
Loading...
