R5911443 /02 UDM92
Image 8-44
2. Identify the projector with the longest delay.
3. For each projector in the setup, select Installation → Warp in the main menu.
Image 8-45: Installation menu, Warp
4. In the Warp menu, select Transport Delay.
Image 8-46: Warp menu, Transport delay
The Transport menu is displayed.
Image 8-47
5. Enter the value either by the arrow keys (one step at a time) or directly by the numeric keys on the remote
control.
6. Enter “Apply” to confirm the value.
7. Repeat this process for every projector in the setup.
GUI – Installation
To Next Page
Loading...
