Barcrest MPU6 - Page 7

7
4.24.11 Status LEDs 67
SECTION 5 ....................................................................................................................68
5.1 MPU6 board replacement 68
5.1.1 MPU6 Connectors 68
5.1.2 MPU6 Removal 68
5.1.3 MPU6 Refitting 68
5.2 MPU6 I/O 69
5.2.1 Speaker Connections 69
5.2.2 Switch Connections (First MPU6 Horizon only) 69
5.2.3 CCtalk Note Acceptor (Horizon Only) 69
5.2.4 Hopper (UK Horizon Only) 69
5.2.5 Ardac Note (Acceptor Netplex) 70
5.2.6 Coin Mech 70
5.2.7 Meters 70
5.2.8 Dallas Key (Triple 7 only) 70
5.2.9 Dallas Key (UK Horizon Only) 71
5.2.10 Fan Sense (Triple 7 Only) 71
5.2.11 MPU6 Configuration IButton Cell (Horizon Only) 71
5.2.12 MPU6 Ident IButton Cell (Horizon Only) 71
5.3 MUX5 and MUX5E Board replacement 72
5.3.1 Connector locations 72
5.3.2 Connector Removal 72
5.3.3 MUX5(e) Fitting 72
5.3.4 MUX5(E) Pin listings 75
5.4 REEL5 control board replacement 77
5.4.1 Connector locations 77
5.4.2 Reel 5 PCB Removal 77
5.4.3 REEL5 control board replacement (Starpoint/Gamesman) 77
5.4.4 Connector locations 78
5.4.5 REEL5 PCB Pinout 79
5.5 Power supply replacement 80
5.5.1 Removal 80
5.5.2 Refitting the Switch Mode PSU 80
5.6 Reel assembly (Gamesman) repair 81
5.6.1 Lamp replacement 81
5.6.2 Reel Drum Removal 81
5.6.3 Fitting the reel drum 81
5.6.4 Removing a lamp holder 81
5.6.5 Fitting a lamp holder 81
5.6.6 Lightbox Replacement 82
5.6.7 Fitting the lightbox 82
5.6.8 Opto replacement 82
5.7 Lightbox repairs 83
5.7.1 Lamp replacement 83
5.7.2 Lamp Holder Removal and Replacement 83
5.7.3 Lamp replacement 83
SECTION 6: IBUTTON FUNCTIONALITY AND REGISTRATION..................................84