7-8
HR
, and that segment specified for
TPTB
in
Display Data Set
(in
General Parameters
).
Method
This specifies which option (
Auto
or
Manual
) is to
be used.
Sensitivity Factor
This command adjusts the sensitivity of the peak
search operation. The height of the smallest
detectable peak decreases by a factor of 10 for each
stepwise decrease in the
Sensitivity Factor
.
Find Peaks after
If this command is activated, the
Results Graph
Load Data
will be displayed automatically when a data file is
loaded (if it is not activated, the
Single Graph
will
be displayed)
Find Peaks after
If this command is activated, the
Results Graph
Run
will be displayed when the experiment has ended (if
it is not activated, the
Single Graph
will be
displayed).
Symmetrical and
Select whether Peak Current and/or Peak Area are
Tailing Results Include
reported in the results.
To Next Page
Loading...