Baur DTA 100 C

DTA 100 C Product information
822-129-8 17 / 90
3.3 USB interface
The USB interface is used:
 to connect to a PC for communicating with the BAUR ITS Lite software for managing
measurement data (free download: http://www.baur.eu),
 for firmware updates performed by a BAUR representative.
Type of interface:: USB Type B
3.4 Power supply
The voltage supply for DTA 100 C can be provided via an existing mains supply on site.
Permissible mains voltage: 90 – 264 V
Permissible mains frequency: 50/60 Hz
NOTICE
Too high or too low mains voltage
A low mains voltage adversely affects the function of the system, a high mains
voltage can cause damage.
 Ensure that the supply voltage matches the specifications on the rating plate.