Baur DTA 100 C

Basic insulating oil test procedure DTA 100 C
20 / 90 822-129-8
1. Installing the oil breakdown voltage tester
2. Connecting the oil breakdown voltage tester to the
power supply
3. Earthing the oil breakdown voltage tester (if
operated in a laboratory)
4. Turning on the oil breakdown voltage tester
5. Select the electrodes specified in the standard
6. Insert the electrodes in the test vessel
7. Set the electrode distance
8. Fill the test vessel with the oil sample
9. Insert the test vessel into the oil breakdown voltage
tester
10. Performing the measurement
11. Print and/or save the measurement log
12. Remove the test vessel from the oil breakdown
voltage tester
13. Dispose of the oil sample
14. Switch off the oil breakdown voltage tester
5 BASIC INSULATING OIL TEST PROCEDURE