Baur DTA 100 C

DTA 100 C Maintenance
822-129-8 77 / 90
16.4 Replacing the fuse
Prerequisites
Mains fuse: 250 V / 4 A time lag, rated breaking capacity 1500 A (H)
Procedure
1 Latches
2 Fuse cartridge
3 Fuses
4 Groove
1. Press both latches (1) inwards and remove the fuse cartridge (2).
2. Replace the fuses (3).
3. Place the fuse cartridge (2) in the groove (4) so that it snaps in place.
16.5 Calibration
The product has been inspected, adjusted and calibrated for its functions before delivery.
The customer will receive a log which will also document the feedback of calibration
quantities. If required, a test and calibration log can be delivered with the proof of return of
the calibration to national and international standards.
BAUR GmbH recommends calibrating the device once a year to guarantee maximum
accuracy.
In case of questions, please contact BAUR GmbH or your local BAUR representative
(http://www.baur.eu/baur-worldwide).