Remote Control20
English
13. MENU
Press this button to display the OSD (on-screen display) menu for adjusting the image, sound
and functions. The function table allows you to use the or buttons to select items. Pressing
the button again removes the OSD display.
14. INPUT
Press this button to select an input source.
15. ///and OK button
• : press the or buttons to select settings.
• : press the or buttons to adjust OSD menu settings.
• Press OK to execute selections, or to enter a submenu you have selected.
16. FAVORITE
Press this button to jump to the five favorite channels you have set.
17. EXIT
When operating the on-screen display, press this button to return to the next higher menu level.
18. CH /
Press this button to change channels.
19. VOL /
Press these buttons to raise or lower the volume.
20. MUTE
Press this button to mute the sound. Press it again to restore audio.
21. MTS
Press this button to select various audio systems (different television systems have different
selections).
22. Channel select
Press these buttons to select the channel you wish to view.
23. RECALL
Press this button to toggle between two channels.
Using the Remote Control
When using the remote control, aim it at the remote control sensor window on the television. If
there is an object between the remote control and the signal remote control sensor window on
the television, the remote may not operate.
When using the remote control, please note:
• Do not strike or drop the remote. Do not expose the remote control to liquids and do not place it
in humid environments.
• Do not install or place the remote control in direct sunlight. The heat may damage the remote
control.
• If the remote control sensor window on the television is in direct sunlight or strong light, the
remote control may not operate normally. In this situation, change the light source or readjust
the angle of your television, or operate the remote control from a location closer to the remote
control sensor window on the television.
To Next Page
Loading...
