61
Stopped T/T
0.2 Hz +0%
DRV: Freq Mode 1
05 Keypad
DRV: Drive Mode 1
04 Keypad
Stopped K/K
0.2 Hz +0%
DRV: Jump Code
00 11
5 - KEYPAD OPERATION AND PROGRAMMING
5.9.1 Easy Start Up
Operation from a Two Wire Start/Stop Circuit & Analog Input
1. First press the loc/rem button to switch the control mode from “LOC” to “K/K”.
2. Press [MENU] key until the following screen appears:
3. Using the [UP] arrow key scroll to the following parameter:
4. Press [ENTER] key to select.
5. Using the [UP] arrow key select “Terminal 1”.
6. Press the [ENTER] key to save the setting.
7. The VFD can now start and stop via a dry contact closure. This contact closure should be between the
terminals FWD and +24 control.
8. After you have DRV 04 set to “Terminal 1” press the [UP] button to have the display screen shown
below.
9. Press [ENTER] key to select.
10. Using the [UP] arrow key select “Vin1”.
11. Press the [ENTER] key to save the setting.
12. Press [MENU] button until the following screen is displayed.
z NOTE: See page 54 for more information on Control Modes.
z NOTE: See page 43 to see the S4 Wiring Diagram.
To Next Page
Loading...
Need help?
General
