Embroidering preparation
32
2019-02 EN 5020070.00A.04
> Push the bobbin to the right.
> The button «Start/Stop» flashes and the display for winding appears.
> Hold the thread end with one hand.
> To start the winding process for a few rotations and then stop, push the button «»Start«/Stop», so that
the thread is held tight on the bobbin.
> Cut the thread end next to the inner hole.
> To continue the winding process, push the button «Start/Stop» or press the foot control.
> To stop the winding process, push the button «Start/Stop» or press the foot control.
> Remove the bobbin and cut the thread.
Threading the bobbin thread
Prerequisite:
• The needle is raised.
• The presser foot is raised.
• The machine is switched off.
> Open the bobbin cover by pushing the release button to the right.
To Next Page
Loading...
