Bernette DECO B70 - Deactivating Securing Stitches; Adjusting the Thread Cut

Setup Program
46
2022-08 EN 5020070.40A.04
> Center the needle via the arrow icons on the display and confirm.
Deactivating Securing Stitches
> Tap «Setup Program».
> Tap «Embroidery Settings».
> Tap «Securing Stitches On/Off».
> Tap the switch in the lower left area to deactivate the securing stitches.
– No securing stitches will be sewn and the bobbin thread needs to be brought up manually and held
when embroidering is started.
> Tap the switch again to activate the securing stitches.
Adjusting the Thread Cut
> Tap «Setup Program».
> Tap «Embroidery Settings».
> Tap «Thread Cut Settings».
> To deactivate the automatic thread cut before changing a thread, tap the switch in the upper section of
the display (1).
> To activate the automatic thread cut before changing a thread, tap the switch in the upper section of the
display (1) again.
> To deactivate the manual thread cut after embroidering, tap the switch in the lower section of the display
(2).
– The machine won't stop for a manual thread cut.
> To activate the manual thread cut after embroidering, tap the switch in the lower section of the display
(2).
– The machine will stop after about 7 stitches.