Bernette DECO B70 - Checking Design Size and Position; Deleting an Embroidery Design

Creative embroidering
59
2022-08 EN 5020070.40A.04
Checking the Size and the Position of the Embroidery Design
It can be checked whether or not the embroidery design matches the designated position/location on the
fabric.
> Select the embroidery design.
> Tap «i-Dialog».
> Tap «Check Embroidery Design Size».
– The embroidery hoop travels all the way until the needle is at the position as it is indicated in the
display.
– If the embroidery design hasn't been positioned correctly yet, the position can be altered via the
«Upper/Lower Multi-function Knobs» and the complete embroidery positions can be checked again.
> To position the needle in the center of the embroidery design, tap «Center of Embroidery Design».
> Turn the «Upper Multi-function Knob» to move the embroidery design horizontally.
> Turn the «Lower Multi-function Knob »to move the embroidery design vertically.
Deleting an Embroidery Design
The active embroidery design is deleted.
> Select the embroidery design.
> Tap «i-Dialog».
> Tap «Deleting».
> To delete the embroidery design, tap «Confirm».