124
Preparing for embroidery
1
2
Embroidery hoop
Center determination
⦁
determine the center of the material to be embroidered
⦁
mark the material with fabric marker or chalk
Using the embroidery hoop
⦁
loosen the screw 1 of the outer hoop if necessary
⦁
remove the inner hoop
Match the arrows 2 of both hoops.
The arrows are
on the oval and medium hoop at the center front
on the Mega Hoop (optional accessory) at the center front
on the small hoop (optional accessory) to the right side
Embroidery template
there is an embroidery template for each hoop
the embroidery area is marked in 1cm squares
the center and end point holes of the center lines are with holes
⦁
for transferring marks to the material
⦁
attach the embroidery template holder
⦁
place the template in the inner hoop, so the BERNINA logo is at the front
edge (by the arrows) and can be read
►
in this position the embroidery template clicks into the inner hoop
Hooping the material
⦁
place the material under the inner hoop
⦁
line up the marked center point on the center of the template
⦁
place the material and inner hoop on the outer hoop
Match the arrows of both hoops.
⦁
fit hoops into each other; ensure that the material does not
move
⦁
hoop the material to be embroidered tightly
⦁
tighten the screw
⦁
remove the template from the hoop by using the template holder
To Next Page
Loading...
