Berthoud TRACKER User Manual

82.503 TRACKER / TRACKER-S D.P.A 15
-Putthesprayeronaat,hardsurface.
- Put the sprayer in its parking position.
- Tighten the parking brake.
- Disconnect the electric connections.
- Disconnect the hydraulic connections.
- Rest the hydraulic pipes on the sprayer mountings intended for this purpose.
- Disconnect the drive shaft from the tractor.
- Rest the drive shaft on its support so as not to damage its protectors.
- Unhitch the sprayer.
UNHITCHING THE SPRAYER
- Check the condition of the protectors on the drive shafts.
- Make sure that there is no foreign matter into the tank.
- Check the oil levels and the greasing of the various elements (see "Lubrication and greasing" section).
-Checkthecleannessofthelters:
- Suction,
- delivery.
CHECKS TO BE CARRIED OUT EVERY TIME BEFORE
THE SPRAYER IS USED
CAUTION
- For your convenience,
 theelectronicunithasbeenprogrammedwiththeoretical
values corresponding to your sprayer’s characteristics.
In all cases, you must check and possibly correct the
values programmed.
WHEN STARTING
- Start-up the motor.
- Use switch (1) to power-up the unit (pages 16 and 17).
- Engage the power take-off.
CHECKS
- When starting the campaign, systematically check that the
nozzle pressure is below 3 bar for 1 minute.
- Reprogram the new value. If this is higher than the initial
value by 10%, you must replace the nozzles.
CAUTION
- ALL THE VALVE AND THE INDEXES OPERATIONS
MUST BE CARRIED OUT WITH THE POWER TAKE-OFF
STOPPED.
RECOMMENDATIONS FOR USE

Berthoud TRACKER Specifications

General

Brand	Berthoud
Model	TRACKER
Category	Farm Equipment
Language	English