ENGINE
4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil filter element is also to be replaced,
perform the following procedure.
▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Remove the oil filter element cover “1” and oil
filter element “2”.
b. Install a new O-ring “3”.
c. Install the new oil filter element and the oil fil-
ter element cover.
▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
6. Check:
• Engine oil strainer
Dirt → Clean.
7. Install:
• Engine oil strainer
• Spring
• O-ring
• Engine oil drain plug
8. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
9. Install:
• Engine oil filler cap (dipstick)
10.Start the engine, warm it up for several min-
utes, and then turn it off.
11.Check:
• Engine
(for engine oil leaks)
12.Check:
• Engine oil level
13.Check:
• Engine oil pressure
▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Slightly loosen the oil check bolt “1”.
b. Start the engine and keep it idling until engine
oil starts to s
eep from the oil check bolt. If no
engine oil comes out after one minute, turn
the engine off so that it will not seize.
c. Check the engine oil passages, the oil filter
element and the oil pump for damage or leak-
age.
T
R
.
.
Oil filter element cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1
2
5
4
3
2
1
2
3
New
T
R
.
.
Engine oil drain plug
32 Nm (3.2 m·kgf, 23 ft·lbf)
Engine oil quantity
Total amount
1.15 L (1.22 US qt, 1.01 Imp.qt)
Without oil filter element replace-
ment
0.95 L (1.00 US qt, 0.84 Imp.qt)
With oil filter element replace-
ment
1.00 L (1.06 US qt, 0.88 Imp.qt)
New
1
To Next Page
Loading...
Need help?
General
