46
If set ON (as indicated by the graphic C appearing in the middle of
the screen) and Started, the Chronograph will continue to run in
the background while on the Surface after a dive until it is Stopped
by button action or the unit shuts Off automatically, at which time
the Chrono will Stop and Reset to :00:00 (hr:min:sec).
The d.i.P will automatically shut Off 3 hours after surfacing from a
last dive. Upon subsequent manual (button) or Wet activation, the
NORM SURF MAIN screen will be displayed and Surface Interval
time will be displayed as :00:00 (:min:sec) (Fig. 49). The graphic
SF will not be displayed like it is after surfacing from a dive.
CHRONO START/STOP/RESET Display, (Fig. 50)
• Graphics CHR and ON (if ready or running) or OFF (if stopped)
• Chrono Time
• Clock icon
> Press/release the S (Select/Right) button (< 2 seconds) to Stop
or Start the Chrono.
> Press the S (Select/Right) button for 2 seconds to Reset the
Chrono to :00:00 (:min:sec) after it is Stopped.
> Press/release the A (Advance/Left) button (< 2 seconds) to view
the NORM MEMO Display.
> The display will revert to the NORM SURF MAIN screen after
2 minutes if no button is pressed or if Both buttons are pressed
simultaneously for 2 seconds.
Fig. 49 - ACTIVATION (WET)
Fig. 50 - CHRONO READY TO
START
SI
To Next Page
Loading...
Need help?
General
