74
OPERATING MODES
• NORM (Normal Digital Gauge)
• NAV (Navigational Gauge)
NORM SURFACE MODES
• Activation/Diagnostic
• Altitude/Battery Status Check
• Surface
• Chronograph Start/Stop/Reset
• Dive Memo (Log) - Date/Time, Dive Data, O2 Data
• Historical (History)
• Set NAV (On or Off)
• Set Mode 1:
• Max Depth Alarm (6, 7, 8, or 9 to 120 M) or
(20, 23, 26, or 30 to 400 FT )
• Elapsed Dive Time Alarm (:10 to 9:00 hr:min)
• Ascent or Chrono Mode
• Backlight Duration (0, 5, or 10 sec)
• Max PO2 Alarm (1,20 to 1,60 ATA)
• FO2 (Air, 21 to 100% O2)
• PC Interface (to Upload Settings or Download data)
• Set Mode 2:
• Units of Measure (Metric or Imperial)
• Hour Format (12 or 24)
• Time (Hour, Minute)
• Date (Year, Day, Month)
• Sampling Rate (2 , 15, 30, or 60 sec; or
0,5 , 1,5 , or 3 M; or 2 , 5 , or 10 FT),
• Audible Alarm (On or Off)
• Wet Activation (On or Off)
• Serial Number (and Firmware Revision)
• Ascent Scale (Standard or Navy)
NORM DIVE MODE
• Main - default (Current Depth, Max Depth, Elapsed
Dive Time, Ascent Rate Bar Graph, and if On -
Chrono Time or Digital Ascent Rate)
• Chronograph Start/Stop/Reset
• Alternate 1 (Current Depth, Temperature, Time of
Day, Elapsed Dive Time, Ascent Rate Bar Graph)
• Alternate 2 - only if a nitrox dive (Current Depth,
Current PO2, Elapsed Dive Time, Ascent Rate Bar
Graph)
• High PO2 (1,20 to 1,60 ATA)
NAV MODE (on Surface < 0,6 M/2 FT)
• Activation/Diagnostic
• Surface (dashes before dive for Depth, Nav Heading,
Nav CDT, and Nav SN; 0:00 for EDT; actual after
dive)
• Set NAV (On or Off)
• SN (NAV Leg) Preview
• PC Interface (to Upload NAV Settings)
• Set Max Depth Alarm (9 to 120 M / 30 to 400 FT)
• Set Units of Measure (Metric or Imperial)
• Set Backlight Mode (Constant On or Time Out)
NAV MODE (underwater => 0,6 M/2 FT)
• Current Depth
• NAV Heading, CDT, and SN (Leg #) - if accessed
• EDT (Elapsed Dive Time)
SPECIFICATIONS
To Next Page
Loading...
Need help?
General
