61
SET NAV BACKLIGHT MODE
NAV Backlight Mode controls whether the Backlight remains ON
after the S button is released to activate it (i.e., stay ON Con-
stantly), or turn OFF after the Time Out Duration set in the NORM
SET 1 menu (0, 5, or 10 seconds).
• When operating in NAV mode, Backlight Level (illumination)
will be 50% of the NORM Mode's 100% Level of illumination.
To access the Set NAV Backlight Mode screen while viewing the
SET NAV screen, press/release the A (Advance/Left) button 5
times (< 2 seconds each time).
• The graphic GLO will appear with the Set Point CON (Con-
stant) or tot (Time Out) flashing (Fig. 66A/B).
> Press/release the S (Select/Right) button to toggle between the
selections.
> Press/release the A (Advance/Left) button to accept the setting
and revert to the SET NAV screen.
• Operation reverts to the NAV DIVE MAIN (Surface) screen in 2
minutes if no button is pressed.
NOTE: To change any of the other settings such
as Wet Activation, Backlight Duration, Time/Date,
etc., NAV MODE must be set OFF in the SET NAV
screen (see page 55), then the A (Advance/Left)
button pressed/released (< 2 seconds) to gain ac-
cess to the NORM SURF MAIN screen.
Fig. 66B - SET NAV BACKLIGHT
MODE (TIME OUT)
Fig. 66A - SET NAV BACKLIGHT
MODE (CONSTANT)
To Next Page
Loading...
Need help?
General
