EasyManuals Logo

Beuchat d.i.P User Manual

Beuchat d.i.P
Go to English
159 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #124 background imageLoading...
Page #124 background image
45
MEMO Data will not be recorded in the unit's memory until the 5
minute Transition Period on the surface is completed.
If you Descend during the 5 minute Transition Period, EDT
(Elapsed Dive Time) will restart from the time that you descend
(i.e., a continuation of that dive). The time at the surface (if less
than 5 minutes) will not be added as EDT.
AFTER THE FIRST 5 MINUTES (UP TO 3 HOURS)
Once 5 minutes have elapsed, the Surface Interval time (hr:min)
will be displayed as the lower digits with the graphic SF indicating
Post Dive Surface Time (Fig. 48). A subsequent Descent would
then be considered a new dive and EDT would again start at :00:00
(:min:sec).
For the remainder of the next 3 hours after surfacing, information
will be displayed as the POST DIVE NORM SURF MAIN screen
and you will have full access to other modes (e.g., Chrono, Memo,
History, Set, PC).
> To access the Chrono (if set ON) then the Memo then History,
press/release the A (Advance/Left) button (< 2 sec each time).
> To access the Set Sequence, press/hold Both buttons for 2 sec-
onds.
> To activate the Backlight, press/release the S (Select/Right) but-
ton (< 2 sec).
Fig. 48 - POST DIVE
AFTER 5 MINUTES

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beuchat d.i.P and is the answer not in the manual?

Beuchat d.i.P Specifications

General IconGeneral
BrandBeuchat
Modeld.i.P
CategoryDiving Instrument
LanguageEnglish

Related product manuals