33
Fig. 33 - SET WET ACTIVATION
To access the Set Wet Activation screen while viewing the SET 2
screen, press/release the A (Advance/Left) button 10 times (< 2
seconds each time).
• The graphics ACt and H2O appear with the setting flashing
(Fig. 33).
> Press/release the S (Select/Right) button to toggle between ON
and OFF.
> Press/release the A (Advance/Left) button to accept the setting
and revert to the SET 2 screen.
• Operation reverts to NORM SURF MAIN in 2 minutes if no
button is pressed.
SERIAL NUMBER
To access the d.i.P Serial Number screen, press Both buttons si-
multaneously for 2 seconds while viewing the SET 2 screen, re-
lease when the view only SN screen appears.
NORM SURF MAIN >> SET NAV >> NORM SET 1 >> NORM SET 2 >> SN
• The graphic SN appears with numerical d.i.P's Serial Number
and firmware Revision (r) number (Fig. 34).
> Press Both buttons for 2 seconds to access the ASCENT
SCALE screen.
• Operation reverts to NORM SURF MAIN in 2 minutes if no
button is pressed.
Fig. 34 - SERIAL NUMBER
(factory set)