32 - IANUS BT 300 KIT - IANUS BT 500 KIT
D812457 10550_02
57 mm
> 10mm
> 25mm
85mm
Ø 10
Use a base plate as a template and drill a hole at least 60mm deep with a Ø10 mm drill bit� Insert the dowels with a plastic hammer�
Dowels should protrude about 85 mm�
Align the plate with a level so that the motor is even, then place the motor on the plate�
SAFETY DURING INSTALLATION
During installation, please:
- use appropriate tools as specied by these instructions�
- use personal protection equipment (protective goggles, gloves) when working�
- mark work in progress and do not leave the site unattended�
- do not connect the electrical mains until assembly is completed�
- once the equipment is connected to the mains, only touch buttons and adjustment devices necessary to program the unit�
- work and repairs not specied in these instructions are not authorised�
PREPARATION FOR MOTOR MOUNTING
Dowel holes
should be at least
70 mm deep�
To Next Page
Loading...
