BIFFI ICON-040 - Appendix C: ICON3000; ICON3000 AD; C.1 Safety Instructions

December 2019
137
Installation, Operation and Maintenance Manual
VCIOM-08500-EN
Appendix
Appendix
Original spare parts must be ordered from the manufacturer; to ensure that correct
spares are provided, the serial number printed on the ICON3000 product label must be
specied when an order for spares is placed.
Appendix C: ICON3000 / ICON3000AD
Ex db h IIC T4 Gb / Ex h tb IIIC T135°C Db IP66/68
Ex db h ia IIC T4 Gb / Ex h tb IIIC T135°C Db IP66/68
C.1 Safety Instructions
C.1.1 General
This Appendix C to Installation, Operation, and Maintenance Manual MAN-02-04-97-0713
prescribes the Safety Instructions applicable to electric actuators ICON3000-010 and
ICON3000-020. The subject actuator is certied according to EN and IEC Standards 60079-0,
60079-1, 60079-11, 60079-31 and EN ISO 80079-36, 80079-37 for protection type Ex db h or
Ex db h ia for gas group IIIC. The actuator is suitable for installation in an ambient temperature
range from -60 °C (-76 °F) to +85 °C (+185 °F).
 WARNING
Installation, conguration, commissioning, maintenance, and repairs must be performed
by approved and qualied personnel only.
The ICON3000 is designed in accordance with the applicable international rules and
specications, but the following regulations must be observed in every case:
• General installation and safety regulations.
• The proper use of personal protective devices (glasses, clothing, gloves).
• The proper use of tools, lifting equipment, and transport equipment.
C.2 Instructions for Proper Installation
 WARNING
Verify that the actuator nameplate conforms to the applicable certication, ambient
temperature range, and site safety requirements.
Safety warnings and warranty will be invalidated if the ICON3000 is installed in explosive
atmospheres not covered by the appropriate grade of protection, and/or in environments
where temperatures exceed the maximum temperature specied on the product label.