December 2019
167
Installation, Operation and Maintenance Manual
VCIOM-08500-EN
Appendix
Appendix
E.8.3 Repairs
When needed, repairs may only be carried out using spare parts supplied by the
manufacturer. All accessories must comply with approved specications and follow the
application and site requirements.
WARNING
Installation, conguration, commissioning, maintenance, and repairs must be performed
by approved and qualied personnel only.
WARNING
The values of gaps of explosion-proof joints are lower than the maximum specied on
Tables of IEC/EN 60079-1 Standard and the values of widths of the explosion-proof joints
are greater than the values specied in the tables of the Standard IEC/EN 60079-1. Should
maintenance require the replacement of any component that forms part of an explosion-
proof joint, only an original spare provided by Emerson can be used. Direct repair or
reconstruction of the above components is not permitted without Emerson authorization.
Not performing this procedure will invalidate the product safety and contractual guarantee.
Original spare parts must be ordered from the manufacturer; to ensure that correct
spares are provided, the serial number printed on the ICON3000 product label must be
specied when an order for spares is placed.
To Next Page
Loading...
