BIFFI ICON-040 - Nameplate

December 2019
77
Installation, Operation and Maintenance Manual
VCIOM-08500-EN
Section 10: View Routines
View Routines
10.2 Nameplate
Use this menu to view the data identifying the actuator. The data are entered in-house
and can only be changed by the manufacturer. The following data may be viewed:
• Serial number: max. 28 characters, unique identier of the actuator with
reference to the Emerson order acknowledgment.
• Actuator type: max. 28 characters, describes the type of actuator with reference
to the Emerson catalog.
• Torque / Thrust: nominal torque or thrust of actuator.
• Actuator speed: nominal speed of actuator.
• Speed Loop: parameters to set the speed loop (for ICON3000LP (Low Power) only)
• Power supply: nominal voltage and frequency of actuator.
• Motor data: includes the following data relevant to the electrical motor:
- Power type (3ph, 1ph, dc) - Power rating, max. 99.9 kW
- In, max. 99.9 A
- Is, max. 99.9 A/KT (for ICON LP)
- Icc, max 99.9 A/TMax (for ICON LP)
- Duty (S2/15 min, etc.)
- Poles (2, 4, etc.)
- Bif name, max. 28 characters
- Gear ratio, max. 1000 /M.R. Ratio (for ICON LP)
• Test date: date of the in-house functional test of actuator.
• Wiring diagram (WD): wiring diagram number, max 28 characters.
• Enclosure: type of enclosure (Ex d, etc.), max. 28 characters.
• Certicate: number of certicate, max. 28 characters.
• Lubricant: type of lubricant, max. 28 characters.
• Revision: hardware revision of base card, software revision of H8 microprocessor,
software revision of PIC microprocessor.
• Torque sensor: data relevant to the relationship between motor torque and
speed. This set of data also includes the factory torque limit setting, “Torque set
CL” and “Torque set OP”.
View Procedure
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language according to the instructions (see “Entering the view
mode”). When the message displayed is “VIEW MODE OK?” press YES. Press
NO to scroll through the list of available menus and press YES to select the
"Nameplate" menu.
• Press YES to answer the prompt “view” or “next” and see the data in the above list.
Routine Parameters
Stroke limits
Close direction (CW, CCW), close limit type (torque or position),
open limit type (torque or position)
Torque set-up Closing torque limit %, opening torque limit %
ESD control ESD action, signal type, ESD priority
Remote controls Control type
Local controls Control type, color of LEDs
Output relays Monitor relay conditions, ASi conditions, contact action
Positioner *
Dead band, motion inhibit time, polarity, %min, %max (%min and %max
are present only if “position request R%” is from 4-20 mA input)
Fail Safe * Action, delay
Out 4-20 mA * Output signal (position or torque), polarity
Interlock Signal type in OP, signal type in CL
2-speed timer
Close direction: status, start, stop, on time, off time
Open direction: status, start, stop, on time, off time
Bus * Node address, terminations, etc. depending on eldbus type
Miscellaneous
Time and date, torque mode, lithium battery, torque bypass %,
valve jammed time