3.1 Connection of the terminal to the electrical supply line
DANGER
Check that:
✔ The voltage and frequency of the electrical supply line
corresponds to the indications on the warning plate on the
rear of the terminal (see point 4 Figure 3.1 on page 1-17 );
✔ the mains outlet socket to which the terminal is connected
is equipped with an earth;
✔ the warning and danger signs are present and legible;
✔ failing this, notify your maintenance personnel or contact
our Assistance Service directly;
For the correct connection of the terminal to the electrical supply line,
proceed as follows:
✔
plug the 3-pin connector of the power lead into the connector on the
rear if the terminal;
✔
insert the plug of the power lead into the correct mains outlet socket.
The terminal complies with the European Directive for electromagnetic
compatibility, however it is good practice to provide a separate power
supply line for the terminal.
D410
1-18
To Next Page
Loading...