In both operating modes, on completion of the saving operation, the user
can display the progressive number associated with the weighing
operation (see par. 6.6.4 on page 1-73 ).
Code MPP will only appear on the display when the memorising
operation is enabled with the key.
Both the weighing terminal and the PC may signal errors caused by
failure to transfer or save the data correctly. In this event, follow the
on-screen instructions.
6.6.3 Disabling MPP
It may sometimes occur that you do not wish to transfer the weight data
or save it in the MPP memory.
In this case, to disable MPP, type:
...>MENU> MPP operation>De-activated
To subsequently re-enable MPP operation:
...>MENU>MPP operation>with memory
WARNING
Disabling MPP may compromise the operation of equipment
connected to the weighing system in that data transfer to
such equipment will be inhibited.
You can also access the MPP operation menu by pressing the shortcut
key MPP.
D410
1-72
To Next Page
Loading...