8. TROUBLESHOOTING
If the suggested remedy does not solve the problem, contact Assistance
Service.
8.1 Malfunctions
Problem
Cause
Remedy
No power
Check that power arrives at
the mains outlet socket.
The terminal
does not switch
on
Check that the mains lead is
correctly plugged in.
Check that the ON/OFF switch
is in the position I (ON).
Check the fuses.
Adjust contrast
(set to minimum)
Switch on the terminal while
holding pressed .
The display
backlighting is
on, but no data
are displayed
After a few seconds, the
display will show the "CB" logo
with the contrast set to
maximum, after which the
contrast will gradually be
reduced.
Release and then press it
again to set the contrast at the
required level.
- -
Switch off the terminal, unload
the scale then power the
terminal again.
Zeroing
off-range on
powering
D410
1-79
To Next Page
Loading...