8.2 Error messages
Problem
Cause
Remedy
The scale is
overloaded.
9999999
flashing
Reduce the weight to a value
below the maximum scale
capacity.
-01-
Converter fault. Contact Assistance Service.
Switch off the terminal and
check that the connector is
properly connected.
Scale connector
disconnected or
broken.
If necessary, disconnect and
then re-connect the connector.
Switch the terminal back on.
Digital cells fail
to respond
Switch the terminal off and
then on again.
-02-
EEPROM error Switch the terminal off and
then on again.
-04- RAM checksum
error
Switch the terminal off and
then on again.
-05-
PROGRAM
checksum error
Switch the terminal off and
then on again.
Switch the terminal off and
then on again.
-06-
Serial number
error on digital
cell
D410
1-80
To Next Page
Loading...