5. USE OF THE TERMINAL
5.1 General
5.1.1 Using the keys to navigate the menus
The numeric keys described in par. 4.3 on
page 1-33 and the customisable keys e par. 4.2 on page
1-31 can be used to navigate the programming menus.
From the normal weight display condition, you can access the menus by
pressing to select the option 2°F . Now use the other keys to select
the next option. A maximum of 6 functions are available on the bar of the
shortcut keys. By pressing the key in correspondence with the indication
OTHERS you can switch to other functions managed by the terminal. The
arrow keys ↑ , ↓ , → , ← allow you to move respectively up, down,
right and left.
By pressing SELECT you can select the required option or enter a
submenu.
The keys # and \\ allow you to change the way the menu pathway is
displayed : # extended pathway, \\ pathway expressed numerically.
Selecting ESC returns you to the previous menu level. By pressing ESC
repeatedly you can therefore exit through the menus to return to the
normal weight display mode. Form here on in this manual, the
instructions will only indicate the pathway without referring to the specific
keys to be pressed. For example, the instruction on how to change the
contrast will be given as follows:
2°F>CONTR>+ o ->SAVE>ESC
D410
1-37
To Next Page
Loading...