extraction mode to slow extraction mode.
On pressing the key in correspondence with the indication START , the
extracted weight value is zero-set and scale loading is enabled. The
display shows the gross weight (the weight on the scale) and the
extracted weight (the weight gradually loaded onto the scale).
The display format used in this operating mode is Extraction (see
par. 5.2.4 on page 1-42 ).
The extraction operation can be concluded by pressing STOP.
5.4.4 Unloading extraction operation
This operating mode is identical to the previous mode except that in this
case you start with a loaded scale and gradually remove material.
Enter the Set Point 01 and Set Point 02 values ( par. 5.2.8 on page 1-46
).
On pressing the key in correspondence with the indication START , the
extracted weight value is zero-set and scale unloading is enabled. The
display shows the gross weight (the weight on the scale) and the
extracted weight (the weight unloaded from the scale).
The display format used in this operating mode is Extraction (see
par. 5.2.4 on page 1-42 ).
The extraction operation can be concluded by pressing STOP.
5.5 MPP operation
The 4 previous operating modes may be associated with MPP operation,
which is described in detail in par. 6.6 on page 1-71 .
D410
1-55
To Next Page
Loading...