5.2.8 Setting the outputs as Setpoints (if enabled)
The two available outputs may be used in setpoint mode. In this way, the
output is activated when the weight reaches the set value.
...>MENU>Data management>Set Point
(Shortcut key SETPNT ).
Enter the required weight values as described in par. 5.1.2 on page
1-38 .
5.2.9 Setting the outputs as ranges (if enabled)
The two available outputs may be used in Range mode. The output is
activated when the weight is within the set range; to set the range, follow
the pathway:
...>MENU>Data management>Range
(Shortcut key RANGE ).
5.2.10 Generic code
This is an alphanumeric code with a maximum of 8 characters that can
be printed and/or transmitted. The maximum of codes that can be
entered varies according to the other types of data managed. To enter a
generic code follow the pathway:
...>MENU>Data management>Code management>Generic code
(Shortcut key GCCOD ).
Enter the alphanumeric code as described in par. 5.1.3 on page 1-38 .
If the value of the generic code = empty space, it will no longer appear in
the printout and will not be used for totalization.
D410
1-46
To Next Page
Loading...